Skip to content

How I Hacked my Stationary Bike and Voided its Warranty

March 19, 2014
IMG_20140318_184639

Working out is good for your mood, your motivation and energy levels. It’s good for staying thin and looking good, too. Still, going to the gym is impractical. Especially in a city with a harsh winter like Montreal. I just haven’t been able to motivate myself to make that kind of time commitment. Still, I found a nice compromise. I bought myself a Schwinn A10 stationary bike and set it up right next to my desk at home. That way, I can hop on it whenever I want, right in the middle of a coding session. Hit an annoying bug? Need some time to think? Why not take a break to watch a few minutes of an interesting talk while biking. This works pretty well for me, I now do cardio almost every day.

I like my stationary bike: the mechanism is quiet and sturdy, it offers a good resistance level. Unfortunately, it has a slight design flaw. After 5 minutes of inactivity, it goes into sleep mode, and then, if you leave it in sleep mode for more than one minute or so, all of your workout stats get erased. It seems that when it goes in sleep mode, the microcontroller driving it gets powered off completely, and its RAM only survives so long without a refresh. This is problematic since, as I said earlier, I often like to workout in short sessions of a few minutes each, stretching over several hours. Being the tinkerer that I am, I started thinking about ways to work around this problem. I don’t have awesome soldering skills and I didn’t think I could reverse engineer the stationary bike’s control board, but I did think of something.

IMG_20140318_175753 IMG_20140318_184639 IMG_20140318_205224

I designed and built a small board with a microcontroller and a reed relay (low power relay) to trigger a button on the console every 3 minutes. I chose the very basic and inexpensive Atmel ATtiny85 for this. The reed relay is connected to the “enter” button pins on the bike’s control board. Some of you are probably thinking a microcontroller is overkill for this, that I could have used an NE555 timer. I could have, but that would have made for a more complex electronic design. The microcontroller also allows me to easily trigger the “enter” button exactly 3 times in a row, which changes a setting and then restores it to its original value, essentially performing a noop which only serves to keep the bike’s control board from going into sleep mode.

IMG_20140318_215526 IMG_20140318_215513 IMG_20140318_221144

The circuit was tested on a breadboard before I soldered it on a prototype board. Hot glue was used to install the clandestine board inside the bike’s console. The device draws power directly from the bike’s batteries (4 x D cells). It can be turned on and off with a switch I installed on the front console, and there’s a green panel mount LED to indicate its status. My Schwinn A10’s warranty is no doubt voided now, but the annoying flaw is fixed, and this was a fun little hack to work on. Honestly, I was just curious to see if I could make this work ;)

About these ads
One Comment
  1. Alice Vixie permalink

    :-D keep being TRULY geeky and active

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

Follow

Get every new post delivered to your Inbox.

Join 2,602 other followers

%d bloggers like this: